Series 95:- Door / Window frame having 2 tracks for glass shutter and one for mosquito sash made of uPVC Profile Section of size 95mm x 60mm (wxh) having outer wall thickness of 2.30mm (+/- 0.2mm) and 3 box multi-chamber construction. Sliding shutter shall be made of 66mm x 42mm (or 92mm x 42mm)  having outer wall thickness of 2.40mm (+/- 0.2mm) and mesh shutter shall be of size 50mm x 27mm. Wherever required/specified, system shall have the sash mullion of size 66mm x 42mm having outer wall thickness of 2.40mm (+/- 0.2mm).

All sections of the frame, sash, transom & mullion shall be duly reinforced with G/J/U/O shape galvanised mild steel section considering structural / wind load requirements. All the corners / mullion / transom joints of the frame & sash shall be mitred cut & fusion welded without any mechanical joining. All welded joints are to be neatly trimmed & feature grooved/raised nib finish so as to make the finished product free from all sharp edges & burrs. System shall have adequate drainage mechanism to permit the escape of water from horizontal member beneath each sealed unit.
 
System shall be provided with the suitable uPVC beads for glazing of the system with specified/required glass (single / IGU) and mosquito mesh, duly cut at correct degree & fitted with ‘K’ & ‘O’ type inner and outer EPDM weather seal gaskets.  System is to be provided with proper operating and locking hardware mechanism as per system supplier’s recommendations / buyers’ requirement.

Complete Door/window shall be fixed into the existing pre-finished aperture, by drilling & fixing through the outer frame using high quality fasteners & silicon glue is applied to fill up the crevice between wall & window frame for leak-proof installation.